Brother BAS-341F Instruction Manual page 49

DIP switch A
SW No.
After sewing is completed, work clamp does not automatically rise (only in split mode)
A-5
Clamping force output is produced (Inner clamping device available as an option)
A-6
Single-pedal operation using the starting switch; when the starting switch is pressed, the work clamp
A-7
drops, and when it is released, sewing starts.
Thread breakage detector device is activated
A-8
DIP switch B
SW No.
Single split mode activated
B-1
Feed movement when not using work clamp, activated
B-2
Thread is not trimmed after an emergency stop.
B-3
Needle cooler output is produced.
B-4
When a rotating-type thread breakage detector device is used, detection precision is increased from 8 to 14.
B-5
When a fiber-type thread breakage detector device is used, detection precision is increased from 5 to 10.
Fiber-type thread breakage detector device is ON, and DIP switch A - 8 is ON (available as an option)
B-6
When using a 3-stage pedal
B-7
If DIP switch A -2 is ON at the same time, the presser foot will drop at the same time that work clamp drop.
Feeding speed is switched to high speed.
B-8
When ON
When ON
BAS-341F, 342F
10. DIP SWITCH
42