Using The Emergency Stop Switch - Brother BAS-341F Instruction Manual

6. USING THE OPERATION PANEL

6-5. Using the emergency stop switch

Press the emergency stop switch to immediately stop the sewing machine during actual sewing or when in the test
mode.
(17)
1215S
1219S
(15)
(18)
1200S
21
Clearing the error
1941S
1. Turn the EMERGENCY STOP switch (6) clockwise
2. Press the STEP BACK (RESET) switch (17) on the
3. If you do not wish to resume sewing, press the
* If memory sewing No. 0d is OFF, press the EMER-
Continuing sewing from a stopping point
1215S
If you press the EMERGENCY STOP switch after the
thread breaks or the bobbin thread runs out during sewing,
you can then resume swing from the point where the
thread broke or ran out.
1. Press the EMERGENCY STOP switch to release it.
2. Press the STEP BACK (RESET) switch (17) to trim
3. Press the STEP BACK (RESET) switch (17) once
(17)
4. After you have reached the desired position, depress
BAS-341F,342F
and then pull it forward to release it .
operation panel. (The buzzer will stop sounding.)
EMERGENCY STOP switch (6) once more to release
it, and then press the STEP BACK (RESET) switch
(17) so that the operation panel display flashes. The
sewing machine will then be ready for the next sewing
operation.
GENCY STOP switch (6) once more to release it.
the thread.
more.
(The sewing machine will move stitch by stitch in the
reverse direction while this switch is pressed.)
If the sewing machine moves back too far, press the
TEST switch (15) to move it forward again. Press the
TEST switch (15) again to stop the machine.
the starting pedal to start sewing.