Installing The Mounting Rails In The Rack; Installing Rapidrails Mounting Rails - Dell PowerEdge 2950 Installation Manual

Installing the Mounting Rails in the Rack

Installing RapidRails Mounting Rails

NOTE:
Ensure that the rotating mounting brackets on the slide assemblies are in the RapidRail configuration.
See Figure 1-5.
1 At the front of the rack cabinet, position one of the mounting rails so that its mounting-bracket flange
fits between the marks or tape you placed (or numbered locations) on the vertical rails in "Marking the
Rack" on page 9 (see Figure 1-5).
The top mounting hook on the front mounting-bracket flange should enter the top hole between
the marks you made on the vertical rails.
Figure 1-5. Installing RapidRails Mounting Rails
2
3
front of rack
1 mounting hooks (4)
12
Rack Installation Guide
1
2 push buttons (2) 3 mounting rails (2)