Installing The Tower Trim Panel; Removing The System - Dell PowerEdge 2800 Conversion Manualline

Y1001bk0.book Page 23 Thursday, July 8, 2004 4:32 PM
Figure 1-12. Removing the System
system locking mechanism
system locking
mechanism release button

Installing the Tower Trim Panel

Lay the system on its cover as shown in Figure 1-13.
Position the tower trim panel with the back end extending 12.7 millimeters (0.5-inch) beyond
the back of the chassis. See Figure 1-13
Slide the trim panel toward the front panel until it stops.
Using a #2 Phillips screwdriver or 1/4-inch nut driver, install the two screws that secure the
trim panel to the back of the chassis.
Using a #2 Phillips screwdriver or 1/4-inch nut driver, install the three screws that secure the
trim panel to the side of the chassis.
Tower-to-Rack and Rack-to-Tower Conversion Guide
23