Table of Contents
Advertisement
5.
To mount anti-tip bracket to wood floor, drill two 1/8"(3.2 mm)
holes at the positions marked on the bracket template.
Remove template from floor.
7.
8=
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
Move range close enough to opening to allow for final
electrical connection.
Remove shipping base, cardboard or
hardboard from under range.
Move range into its final location making sure rear leveling leg
slides into anti-tip bracket.
6=
To mount anti-tip bracket to concrete or ceramic floor, use a
3Ae"(4.8 mm) masonry drill bit to drill 2 holes at the positions
marked on the bracket template. Remove template from floor.
Tap plastic anchors into holes with a hammer.
Align anti-tip bracket holes with holes in floor. Fasten anti-tip
bracket with screws provided.
9. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location
Requirements" section.
10. Continue installing your range using the following installation
instructions.
Explosion Hazard
Use a new CSA International
approved
gas supply line.
Install a shut=off valve.
Securely tighten
all gas connections.
if connected to LP, have a qualified
person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples
of a qualified
person include:
licensed heating personnel,
authorized
gas company personnel, and
authorized
service personnel.
Failure to do so can result in death, explosion,
or fire.
Typical rigid pipe connection
A combination
of pipe fittings must be used to connect the range
to the existing gas line. Your connections
may be different,
according to the supply line type, size and location.
1. Apply pipe-joint compound
made for use with LP gas to all
pipe thread connections.
2=
Using a pipe wrench to tighten, connect the gas supply to the
range.
,............ C
{_ .............
D
A
F
G
A. Gas pressure regulator
B. 90 ° elbow (must have
Y2" male pipe thread)
C. Nipple
D. Union
E. Black iron pipe
F. Manual gas shutoff valve
G. Y2"or 3/4"gas pipe
H. Nipple
I. Union
J. 90 ° elbow
Typical flexible connection
1. Apply pipe-joint compound
made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in following illustration).
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
Advertisement
Table of Contents
