Table of Contents
Advertisement
ToConvert S urface Burners
1=
2.
Remove burner cap.
Using a Phillips screwdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range cooktop
to hold the orifice spud holder in place while removing and
replacing the orifice spuds.
A
B
3=
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
Apply masking tape to the end of a sAe"nut driver to help hold
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise
and lifting out. Set gas orifice
spud aside.
A
D
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Surface
Burners
Burner Rating
14,000 BTU
11,000 BTU
8,000 BTU
5,000 BTU
Color
Size
ID Number
Yellow/Orange
1.07 mm
L107
Yellow/Brown
0.99 mm
L99
Yellow/Black
0.85 mm
L85
Yellow/White
0.70 mm
L70
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the storage or warming drawer for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1=
2.
Remove oven racks.
Use a 1/2" combination wrench to turn the orifice hood down
snug onto pin (about 2 to 21/2turns).
IMPORTANT:
Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adjust Oven Bake Burner
Flame" in the "Electronic Ignition System" section.
4=
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
Remove the cardboard orifice spud holder located on the
back of the range near the gas inlet. Gas orifice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct LP gas orifice spud.
A. Orifice hood
B. Pin
A. Groove
15
Advertisement
Table of Contents
