Table of Contents
Advertisement
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Restore the lamp cover to the original
position and tighten the three screws
with the Phillips screwdriver.
Note
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on. (Page 50)
7
Connect the power cord.
The ON/STANDBY indicator lights in
red.
8
Press the
?/1
on.
9
Press the MENU key, and then select
the Setup menu.
46
Replacing the Lamp
key to turn the projector
10
Select "Lamp Timer Reset", and then
press the ENTER key.
11
Select "Execute" with the
then press the ENTER key.
The Lamp Timer is initialized to 0, and
"Change the Lamp and clean the Filter?"
is displayed in the menu screen.
Refer to page 47 for "Cleaning the Air
Filter".
Change the Lamp and clean the Filter?
Yes:
12
Select "Yes" with the
"Lamp Timer Reset Complete!" is
displayed in the menu screen.
Note
To erase a message, press any key on the
control panel of the projector or on the Remote
Commander.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance (www.eiae.org).
Lamp contains mercury. Dispose
according to local, state and federal laws.
V
key, and
No:
v
key.
Hide quick links:
Advertisement
Table of Contents
