Advertisement
Quick Links
PLEASE study these instructions carefully before installing your new Edelbrock Intake Manifold Gasket. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-
Friday, Pacific Standard Time or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.
• Description: This is a replacement intake manifold gasket, which is supplied in the catalog #1500 turbo kit, as well as
the intake manifold kits, #4754 & #4756.
1. Remove the intake manifold as shown in your instructions for part #1500, #4754, or #4756.
2. Clean all gasket mating surfaces. Stuff paper towels into the open intake ports before cleaning to prevent any debris from
entering the engine.
3. Re-install the intake manifold as shown in the #1500 or #4756 instructions, using the new gasket. If your vehicle was not
equipped with air injection, trim the top edge of the gasket (See. Fig. 1) .
4. Torque all intake manifold bolts to 17 ft/lbs., following the sequence below (See Fig. 2) .
Cut along dashed lines
©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc
®
KIT CONTENTS
Qty.
Description
1
Intake Manifold Gasket
Installation Procedure
Torque all bolts to 17 ft./lbs
Fig. 1
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: 1-800-416-8628
Office: (310) 781-2222
E-Mail: Edelbrock@Edelbrock.com
INTAKE MANIFOLD GASKET
(For Honda D16Y8 Engines)
INSTALLATION INSTRUCTIONS
5
3
7
Catalog #15005
2
4
1
6
Fig. 2
Catalog #15005
Brochure #63-0245
Advertisement
