Edelbrock 15002 Installation Instructions

PLEASE study these instructions carefully before installing your new Edelbrock Turbocharger Fastener Kit. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-
Friday, Pacific Standard Time or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.
• Description: This fastener replacement kit contains all necessary hardware to mount the turbine inlet to the exhaust
manifold, and the outlet elbow to the turbine outlet. The hardware is constructed of high-quality stainless steel and can
be used with any Garrett T25 or T28 Turbocharger.
1. Hand tighten the 1.45" long studs into the exhaust manifold, with the shorter threads towards the manifold (See Fig. 1).
2. Hand tighten the 1.75" long studs into the turbine outlet, with the longer threads towards the turbine outlet (See Fig. 2).
3. When attaching the turbocharger to the exhaust manifold, and the turbo outlet elbow to the turbocharger, use an 8mm
washer under each nut, and hand tighten the 8mm x 1.25 nuts onto the studs.
4. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Towards Exhaust
Manifold
©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc
Qty.
K 4 Stud, 8mm x 1.25 x 1.45" long
K 5 Stud, 8mm x 1.25 x 1.75" long
K 9 Nut, 8mm x 1.25
K 9 Washer, 8mm
Installation Procedure
1.45"
Towards Turbine
Inlet
Fig. 1
Edelbrock Corporation
Torrance, CA 90503
Tech Line: 1-800-416-8628
Office: (310) 781-2222
E-Mail: Edelbrock@Edelbrock.com
Kit Contents
Description
2700 California St.
TURBOCHARGER FASTENER KIT
(For Turbocharger Kit #1500)
Catalog #15002

INSTALLATION INSTRUCTIONS

1.75"
Towards Turbine
Towards Exhaust
Outlet
Elbow
Fig. 2
Catalog # 15002
Brochure # 63-0242