Programming A Sequence - Yamaha DDK-7 Owner's Manual

9
NOTE
When entering an Intro
section, check the number of
bars at the top of the display.
192 DDK-7 Owner's Manual

Programming a Sequence

Press the [RHYTHM] button at the top right of the display to call
1
up the RHYTHM Page.
Press the [CATEGORY] button to call up the Rhythm Category
2
Select pop-up menu, then select the Rhythm category
corresponding to the rhythm you want to enter to the sequence.
If you press User category button, you can select a rhythm of
your own creation (User rhythm).
The rhythm menu of the selected rhythm category is displayed.
3
Select the desired rhythm from the displayed rhythm menu.
Select a rhythm section (Main A – D, Fill in A – D, Intro 1 – 3,
4
Ending 1 – 3, or Break) by pressing one of the rhythm control
buttons on the panel.
The selected rhythm and section appears at the top of the display.
Press the [SET] button in the display.
5
One bar of the selected rhythm is entered and its name is displayed as a box in
the rhythm row on the display. When the rhythm is entered, the cursor (colored
orange) will automatically move to one step right. A maximum of 140 bars can
be entered to a single sequence. When you select an ending pattern and press the
[SET] button, an entire ending pattern (more than one bar) is entered.
You cannot enter a rhythm after an ending pattern.
Repeat steps #2 through #5 above to enter the rhythm and create
6
your own rhythm composition.
Turning the power off before quitting or closing the Rhythm Sequence Program erases
any sequences you have made. Before turning the power off, quit the Rhythm Sequence
Program (page 197).