Clearing Fuser Jams - Lexmark X782 Clearing Jams Manual

Clearing fuser jams

1
Clear the paper path. If the jam error message
persists, go to step 2.
2
Open both the upper right and the lower right
access doors (Areas K and L).
CAUTION:
The fuser assembly may be hot. Let
it cool before continuing.
3
Pull down the latches. They slide toward the
center to release the fuser.
4
Pull the fuser out, and set it on a clean, flat
surface.
5
Unsnap the housing and set it aside.
6
Lift up the fuser roller cover and remove the
jam.
7
Close the fuser roller cover.
8
Snap the housing back onto the fuser.
9
Insert the fuser back into the printer.
10
Slide the latches out, and then pull up to
refasten them.
11
Close the doors.
Clearing image transfer unit jams
1
Open the front access door and the left access
door.
2
While holding down the front access door,
insert a folded piece of paper as shown to clear
the paper sensors under the image transfer
unit. Make sure to clear the entire width of the
paper path.
3
Close the left access door and the front access
door. If the jam persists, continue with step Turn
the printer off. Open the front cover..