An Error Message Is Displayed On The Lcd - Canon 2921B002 On-Screen Manual

An Error Message Is Displayed on the LCD

>
Advanced Guide Troubleshooting
An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
Message
The following ink may have run out.
Replacing the ink tank is
recommended.
U041
Print head is not installed.
Install the print head.
U051/
The type of print head is incorrect.
Install the correct print head.
U052
Some ink tanks are not installed in
place.
U072/
More than one ink tank of the following
color is installed.
U071
The remaining level of the following ink
cannot be correctly detected.
Replace the ink tank.
U130
The following ink tank cannot be
recognized.
U043
U140
U150
> An Error Message Is Displayed on the LCD
If the lamp on the ink tank is flashing, ink may have run out.
Replacing the ink tank is recommended.
If printing is in progress and you want to continue printing,
OK
press the button with the ink tank installed. Then printing
can continue. Replacing the ink tank is recommended after
the printing. The machine may be damaged if printing is
continued under the ink out condition.
Routine Maintenance
Note
If multiple ink lamps are flashing red, see
Maintenance
Follow the directions given in your setup sheet to install the
Print Head.
If the Print Head is already installed, remove the Print Head
once and then reinstall it.
If the error is not resolved, the Print Head may be damaged.
Contact your Canon service representative.
Some ink tanks are not installed in the correct position.
(The lamp on the ink tank flashes.)
More than one ink tanks of the same color are installed.
(The lamp on the ink tank flashes.)
Confirm that the ink tanks are installed in the appropriate
positions.
Routine Maintenance
The remaining ink level cannot be correctly detected. (The
lamp on the ink tank flashes.)
Replace the ink tank and close the Scanning Unit (Cover).
Printing with an ink tank that was once empty may damage
the machine.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level.
Press and hold the
then release it.
With this operation, releasing the function for detecting the
remaining ink level is memorized Please be advised that
Canon shall not be liable for any machine malfunction or
damage caused by refilled ink tanks.
Routine Maintenance
Note
If the function for detecting the remaining ink level is
disabled, the ink tank in gray is displayed on the LCD
when checking the current ink level.
Routine Maintenance
The ink tank is not installed. Install the ink tank.
Routine Maintenance
The ink tank is not compatible with this machine. (The
lamp on the ink tank is off.)
Install an appropriate ink tank.
Routine Maintenance
An ink tank error has occurred. (The lamp on the ink tank
is off.)
Action
and check the status of each ink tank.
Stop button for at least 5 seconds, and
Page 666 of 815 pages
Routine