Starting Warm Engine; Stopping Engine - Echo PE-2000 Type 1/1E Operator's Manual

STARTING WARM ENGINE

WARNING
Blade should not move at idle. If blade moves, readjust carburetor
according to Carburetor Adjustment instructions in the manual or
see your ECHO dealer, otherwise serious personal injury may
result.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Primer Bulb
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Starting - Lay trimmer on a flat, clear area and pull recoil starter
handle/rope (D) until engine fires.
NOTE
If the engine does not start after 4 pulls, use Cold Start Procedure.

STOPPING ENGINE

1. Throttle Trigger
Release throttle trigger and allow engine to idle.
2. Stop Switch
Place stop switch in STOP position.
WARNING
If engine does not stop, close choke to stall engine. Have your
ECHO Dealer inspect and repair stop switch before using edger
again or serious personal injury may result.
DANGER
DANGER
P E
OWER
O ' M
PERATOR S ANUAL
PE-2000
A
A
PE-2400
PE-3100
PE-2000
B
D
C
D
PE-2000
A
A
PE-2400
PE-3100
DGER
15