Starting Warm Engine - Echo PE-2000 1 Operator's Manual

4. Starting - Lay trimmer on a flat, clear area. Firmly grasp throttle grip
with left hand and fully depress throttle trigger to wide open
position. Rapidly pull recoil starter handle/rope (D) until engine
fires (or maximum five [5] pulls).
5. After engine fires (or five [5] pulls), move choke lever back to
"RUN" position. Hold throttle trigger fully depressed and pull recoil
starter handle/rope until engine starts and runs. Release throttle
trigger and allow unit to warn up at idle for several minutes.
NOTE
If engine does not start with choke in "RUN" position after 4 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.

STARTING WARM ENGINE

WARNING
Blade should not move at idle. If blade moves, readjust carburetor
according to Carburetor Adjustment instructions in the manual or see
your ECHO dealer, otherwise serious personal injury may result.
1. Stop Switch - Start/Run.
Move stop switch button (A) away from the STOP position.
2. Primer - Pump Bulb.
Pump primer bulb until fuel is visible int he "Clear" fuel return line.
3. Starting - Lay trimmer on a flat, clear area and pull recoil starter
handle/rope (D) until engine fires.
NOTE
If the engine does not start after 4 pulls, use Cold Start Procedure.
DANGER
P E
OWER
O ' M
PERATOR S ANUAL
B
PE-2400
PE-3100
C
D
PE-2000
A
A
PE-2400
PE-3100
PE-2000
B
D
C
D
DGER
17