Maytag MEDE300VW - Performance Series 27 Inch Electric Dryer Use & Care Manual page 13

Strip 5" (12.7 cm) of outer covering from end of cable, leaving bare ground wire at 5"
(12.7 cm). Cut 1 V2" (3.8 cm) from 3 remaining wires. Strip insulation back 1" (2.5 cm). Shape
ends of wires into a hook shape.
3. Connect ground wire (green or bare) of direct wire cable to external ground conductor
screw. Tighten screw.
When connecting to the terminal block, place the hooked end of the wire under the screw of
the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
1°
2.
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and place the hooked end (hook facing right) of the neutral wire (white or
center wire) of direct wire cable under the center screw of the terminal block. Squeeze
hooked ends together. Tighten screw.
D
4°
A. External ground conductor screw
B. Ground wire (green or bare) of power supply cable
C. ¾" ( 1.9 cm) UL fisted strain refief
D. Center silver-colored terminal block screw
E. Neutral ground wire
£ Neutral wire (white or center wire)
Place the hooked ends of the other direct wire cable wires under the outer terminal block
screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
!! !!
JjJ
5. Tighten strain relief screw.
6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
7. You have completed your electrical connection. Now go to "Venting Requirements."
[i
A. External ground conductor screw - Dotted fine shows
position of N_UTRA/_ . ground wire .... before being moved to
center silver-colored terminal block screw.
B. Center silver-colored terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" ( 1.9 cm) UL listed strain relief