Electrical Connection - Bosch WTVC8530UC - Vision 800 Series Gas Dryer Operating And Installation Instructions

supplied parts illustration. It is
illustrated separately from the hose
for clarity.
3. If space permits, attach the
internally threaded (female) end of
the "Y" connector directly to the
cold water faucet (option A as
shown in the illustration above)
and continue to step 6
For optional Installation with Y
Connector
If the "Y" connector cannot be
attached directly, use the short
hose provided to connect the "Y"
connector to the cold water faucet
(option B as shown in the
illustration below), and continue
with steps 4 through 5.
4. Attach the short hose to the cold
water faucet. Tighten the
connection by hand until the
coupling is seated on the faucet.
5. Use pliers to tighten the
connection an additional
two thirds turn.
D Do not overtighten. Damage to the
coupling could result.
6. Attach the "Y" adapter to the short
hose. Tighten the coupling by
hand until it is firmly seated on the
hose.
%
Do not use pliers to tighten plastic
threaded fittings onto plastic or
metal threaded connections.
7. Attach the washer cold water
supply hose to the "Y" connector.
Hand tighten only.
8. Attach the dryer water supply hose
to the other coupling of the "Y"
connector. Hand tighten only.
9. Tighten only metal-to metal
couplings on the "Y" connector
and short hose an additional
two thirds turn using pliers.
%
10.
%
11.
%
12.
13.
Do not overtighten. Damage to
the coupling could result.
Attach the right-angle connector
on the water supply hose to the
inlet valve located at the top left of
the dryer.
Check to see that the rubber
washer does not fall out, and is
properly seated in the right angle
connector.
Hand tighten the coupling until it
is seated on the connector. Do
not use pliers, hand tighten only.
Do not overtighten. Damage to
the coupling could result.
Turn on the water faucet.
Check for leaks around the "Y"
connector, faucet and all hoses.
Electrical Connection
GROUNDING INSTRUCTIONS
The dryer must only be connected
to an individual branch circuit via a
socket which has been properly
installed and grounded.
The household electrical voltage must
correspond to the voltage specification
on the dryer (rating plate).
You will find the rating plate on the
inside of the front panel.
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
i
Connection specifications as well as
the electrical requirements are
stipulated on the appliance nameplate.
Make sure that:
the power cord plug fits into the
socket.
the power cord is acceptable for
use in this application.
the grounding system is properly
installed.
The power cord may be replaced by a
qualified technician or a licensed
electrician only.
Replacement power cords are available
from Customer Service (see page 32).
Volts Hertz Amperes Watts
110 120 60 9 1080
14