Bosch WTVC8530UC - Vision 800 Series Gas Dryer Operating And Installation Instructions page 13

Side by Side
Dimensions for side by side recessed
or closet installation are shown in the
illustration below.
Clearance dimensions A through D
are found on page 11.
Closet Ventilation Requirements
E Top 48 sq,in. (310 sq, cm)
F Bottom 24 sq,in, (155 sq, cm)
Required Installation Space
G Height 37.25 in, (94.6cm)
H Width 54.75in,(t39,t cm)
I Depth 37.25 in. (94.6cm)
Height Requirement if mounted on a
pedestal 52.25in.(132.7 cm)
Under-Counter
Dimensions for under counter
installation are shown in the illustration
below.
Clearance dimensions A through D
are found on page 11.
Required Installation Space
G Height 37.25in.(94.6cm)
H Width 27.50in,(69.9cm)
Width* 54.75in,(139,tcm)
* washer and dryer side by side
I Depth 37.25in.(94.6cm)
D Appliance must not be mounted
on a pedestal for under counter
installations.
Water Connection
This section applies only to dryers
with a water connection. The
connection is found at the top
back of 500 and 800 Series
Dryers with the Steam logo on the
panel.
%;;
Steam
Attach the dryer water supply hose to a
cold water faucet (the faucet must be
located within 4 ft (1.2 m) of the water
inlet valve on the back of the dryer).
It is recommended to have a water
supply pressure of 20 100 psi (1.37
6.89 bar) for best performance.
Since most connections will share the
cold water faucet used by the clothes
washer, a "Y" connector is provided
along with a short hose (if needed) in
order to connect the water supply hose
to the cold water faucet.
Steam Dryer Parts Supplied
The following parts are included with
the shipment of your dryer:
2
0 3
4
1. "Y" connector
2. Short metal-braided inlet hose
3. Rubber washer (inserted in female
end of short inlet hose, shown
separately here for purposes of
clarity).
4. water supply hose
Connecting the Water Inlet Hose
D The dryer must be connected to
the "Y" connector using the water
supply hose provided. Do not use
an old hose.
1. Turn off the cold water tap and
remove the washer water supply
hose from the tap.
2. Check to be sure that the rubber
washer is fully inserted and seated
in the female end of the short hose
prior to continuing. The rubber
washer is shown as item 3 in the
13