Modifying A Group Member; Removing Members From A Group - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Modifying a group member

Modifying a group member involves changing the member attributes. The member attributes define the
authentication method, encryption methods, secrets, and fabric binding, depending on the group type.
• For ISL member attributes, see
• For Port member attributes, see
• For MS member attributes, see
To change the attributes of a group member, enter the group edit command, as shown in the following
example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> security edit
8/20q FC Switch (admin-security) #> group edit G1 10:00:00:c0:dd:00:90:a3
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Name
Group Type
Group Member
Authentication
PrimaryHash
PrimarySecret
SecondaryHash
SecondarySecret
Binding
Finished configuring attributes.
To discard this configuration use the security cancel command.

Removing members from a group

To remove a member from a group, enter the group remove command, as shown in the following
example:
8/20q FC Switch (admin-security) #> group remove group_1 10:00:00:c0:dd:00:90:a3
Table 9.
Table 10.
Table 1 1.
g1
ISL
10:00:00:c0:dd:00:90:a3
(None / Chap)
(MD5 / SHA-1)
(40 hex or 20 ASCII char value) [
(MD5 / SHA-1 / None)
(32 hex or 16 ASCII char value) [
(domain ID 1-239, 0=None)
8/20q Fibre Channel Switch command line interface guide
[None] chap
[MD5 ] sha-1
] 12345678901234567890
[None] md5
] 1234567890123456
[3 ]
97