Deleting End-To-End Monitors - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

The mask is applied to all end-to-end monitors on the port. Individual masks for each monitor on the port
cannot be specified.
Figure 21 Mask positions for end-to-end monitors
perfsetporteemask 1/2, "00:00:ff" "00:00:ff" "00:00:ff" "00:00:ff"
To display the current end-to-end mask of a port
Enter the perfShowPortEeMask command.
The end-to-end mask has 12 fields, each with a value of on or off. See the following example of setting and
displaying an end-to-end mask:
Example: Setting and displaying an end-to-end mask
switch:admin> perfsetporteemask 1/11, "00:00:ff" "00:00:ff" "00:00:ff" "00:00:ff"
The EE mask on port 11 is set and EE counters are reset.
switch:admin> perfshowporteemask 1/11
The EE mask on port 11 is set by application TELNET
TxSID Domain:
TxSID Area:
TxSID AL_PA:
TxDID Domain:
TxDID Area:
TxDID AL_PA:
RxSID Domain:
RxSID Area:
RxSID AL_PA:
RxDID Domain:
RxDID Area:
RxDID AL_PA:
The end-to-end mask is set on slot 1, port 1 1.
The default EE mask value for an E_Port is:
• TxSID = "00:00:00"
• TxDID = "ff:00:00"
• RxSID = "00:00:00"
• RxDID = "00:00:00"
Only the transmit domain is monitored for E_Ports.
To display a monitor
Enter the perfMonitorShow command, as described in

Deleting end-to-end monitors

Enter the perfDelEeMonitor command to delete end-to-end monitors. You can delete all monitors or
specific monitors. The following example deletes the end-to-end monitor number 0 on slot 1, port 2:
switch:admin> perfdeleemonitor 1/2, 0
End-to-End monitor number 0 deleted
342 Administering Advanced Performance Monitoring (APM)
Transmitted from port
SID mask
AL_PA mask
Area ID mask
Domain ID mask
off
off
on
off
off
on
off
off
on
off
off
on
Received by port
DID mask SID mask
"Displaying monitor
DID mask
counters" on page 347.