Obtaining Slot Information - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Table 56 lists the supported configuration options.
configurations.
Table 56 Supported configuration options
Option Number of
domains
1 1
2 2
5 1
1. L_Ports are not supported on the FC4-48 blade.
Table 57 Chassis configuration options
Option Result
1 One 128-port switch (Blade IDs 4, 17 on slots 1–4, 7–10. Blade ID 5 and 16 on slots
5, 6)
2 Two 64-port switches (Blade ID 4 on slots 1–4, 7–10. Blade ID 5 on slots 5, 6)
5 One 384-port switch (Blade IDs 4, 17, 18, 31, and 36 on slots 1–4, 7–10. Blade ID
16 on slots 5, 6)
See Table 54
The following sections contain procedures for obtaining chassis information and for configuring Director
domains using the chassisConfig command.

Obtaining slot information

For a SAN Director 2/128 configured as two logical switches, the chassis-wide commands display or
control both logical switches. In the default configuration, SAN Director 2/128 Directors are configured as
one logical switch, so the chassis-wide commands display and control the single logical switch.
To display the status of all slots in the chassis:
212 Configuring Directors
Maximum number
of ports per switch
128
64/64
384
on page 210 for details about the different blades, including their corresponding IDs.
Table 57 lists configuration options and resulting slot
Supported port Supported
blades CP blades
FC2- 1 6, FC4- 1 6 CP2 or CP4
FC2- 1 6 CP2
FC4- 1 6, FC4- 1 6IP, CP4
FC4-32, FR4- 1 8i,
1
FR4-48
Notes
Option 1 is the
default
configuration
for SAN
Director
2/128.
Option 5 is the
default
configuration
option for
4/256 SAN
Director.