Samsung SCB-3001 User Manual page 13

Operating Your Camera
- MANUAL : You can control shutter speed manually.
(NTSC MODEL - 1/60sec~1/120,000sec, PAL MODEL - 1/50sec~1/120,000sec)
- A.FLK : Select this when you experience picture flicker, this happen when there is
a clash with the installed lighting frequency.
- EXTERN : Use the Shutter Speed Select Terminal on the back of the camera to
control the shutter speed via an external input. You can control the
desired speed as shown in the table below by connecting the terminal to
the Ground Terminal.
SHUTTER 1
1/60(1/50) OFF
1/120(1/100) ON
1/250 OFF
1/500 ON
1/700 OFF
1/1000 ON
1/1600 OFF
1/2500 ON
[ Interlace Mode]
- --- : Shutter speed is fixed at 1/60 sec (1/50 sec).
Notes
• When you use a DC lens, set the shutter mode to --- if color rolling occurs.
• W hen the SHUTTER is set to ESC after selecting the Internal Synchronization Type, the
picture may become unstable if the camera faces a bright fluorescent light. Therefore,
take care when choosing the installation position.
• When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.
• W hen using an external input, Connect the Shutter Speed Select Terminal to the Ground Terminal.
AGC(AUTO GAIN CONTROL) : The higher the gain level, the brighter the screen - but
the greater the noise.
- OFF : Deactivates the AGC function.
COLOR CCD CAMERA
SHUTTER 2 SHUTTER 3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
24
User Guide
- LOW : Allows automatic gain control from 5.3dB to 32dB.
- HIGH : Allows automatic gain control from 5.3dB to 37dB.
SENS-UP : When it is night or dark, the camera automatically detects the light level
and maintains a clear picture if this mode is activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.
Notes
• I f you set the Function Setup button to 'AUTO' mode, You can adjust the brightness by
increasing or decreasing the shutter speed. (x2 ~ x512)
• N ote that the higher the zoom level, the brighter the screen, but the more likely it is that an
after-image will appear.
• A lthough Noise, Spots, and Whitish symptoms may occur in SENS-UP operation when the
zoom level is increased, this is normal.
RETURN : Select this to save the changes in the EXPOSURE menu and return to the
SETUP menu.
White Bal (White Balance)
Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed, select 'White Bal' by using the Function
Setup button so that the arrow indicates 'White Bal' .
2. Select a desired mode using the Function Setup button.
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL
※ Select one of the following 5 modes, as appropriate for your purpose.
ATW : Select this when the color temperature is between 1,700˚K and 11,000˚K.
OUTDOOR : Select this when the color temperature is between 1,700˚K and
COLOR CCD CAMERA
DC
ATW
25
User Guide