Table of Contents
Advertisement
Installation Conditions
(2) Frame
The MR head bias of the HDD disk enclosure (DE) is zero. The mounting frame
is connected to Signal Ground (SG).
Use M3 screw for the mounting screw and the screw length should
satisfy the specification in Figure 3.3.
The tightening torque must be 0.49N•m (5kgf•cm).
When attaching the HDD to the system frame, do not allow the
system frame to touch parts (cover and base) other than parts to
which the HDD is attached.
(3) Limitation of mounting
Note) These dimensions are recommended values; if it is not possible to satisfy
them, contact us.
Bottom surface mounting
2
A
Frame of system
cabinet
3.0 or less
Details of A
3-4
IMPORTANT
2.5
DE
Screw
3.0 or less
Figure 3.3 Mounting frame structure
m (5kgf•cm).
Side surface
2.5
mounting
2.5
PCA
Frame of system
cabinet
Screw
2.5
B
C141-E203-02EN
Advertisement
Table of Contents
