RocketFish RF-WHD200 User Manual page 13

WVAN - One transmitter to multiple receivers
If you have multiple displays, each with its own WirelessHD receiver,
you can switch the WirelessHD output of the WirelessHD transmitter
between receivers.
To switch between receivers:
• Press the HDMI/WVAN switch on the transmitter for three seconds to
change the WirelessHD output on the WirelessHD transmitter from one
WirelessHD receiver to another (this changes the WirelessHD channel).
If it fails to change to the next display (WirelessHD receiver), repeat the
procedure, and make sure that the desired WirelessHD receiver is
powered on and located within the same room as the transmitter.
HDMI-CEC (Consumer Electronics Control) support
For best operation, connect sources which are HDMI-CEC capable
(DVD, Blu-ray player, and so on) to your WirelessHD transmitter. If
your TV is also HDMI-CEC (v1.3a or newer) capable, your TV's OSD
(on-screen display) should let you select any of the HDMI-CEC source
devices connected to the WirelessHD transmitter adapters on the
WVAN.
Turning off an HDMI-CEC enabled TV sends a broadcast message to
all wired HDMI and WirelessHD source devices, giving them the
opportunity to power off automatically (if they support HDMI-CEC
and this option is enabled in the device's settings).
Similarly, when an HDMI-CEC enabled source device (such as a
Blu-ray player) is connected to the WirelessHD transmitter and the
WirelessHD receiver is connected to an HDMI-CEC enabled TV,
pressing the Play button on the Blu-ray player's remote does the
following:
• Turns on the Blu-ray player
RF-WHD200 13