Chapter 88 Wireless Managed Ap Command List - D-Link DWS-3160-24TC Cli Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
Chapter 88 Wireless Managed AP
config wireless ap <macaddr> [debug [disable | enable] | radio <int 1-2> {channel <int 1-165> |
power <int 1-100>}(1)]
delete wireless ap_neighbors
config wireless ap_download [image_type [img_dwl8600 | img_dwl3600-6600] <url> |
group_size <int 1-12> | abort | start [all | <macaddr> | image_type [img_dwl8600 |
img_dwl3600-6600]]]
show wireless ap_download
show wireless ap {[<macaddr> {[radio <int 1-2> {[channel | power | radar | statistics | neighbor [ap
| client] | vap {<int 0-15> {[statistics]}}]} | statistics | rf_scan {[rogue_classification |
triangulation]} | dist_tunnel {statistics}]} | radio | rf_scan]}
reboot wireless ap [<macaddr> | all]
download wireless ap_image image_type [img_dwl8600 | img_dwl3600-6600] tftpserver
<ipaddr> src_file <path_filename 64>
88-1 config wireless ap
Description
This command is used to provide management of an access point managed by the Wireless
Switch. The new channel, power, debug mode and required password are not saved in the
configuration on the Switch. They are only maintained until the next time the AP is discovered.
Format
config wireless ap <macaddr> [debug [disable | enable] | radio <int 1-2> {channel <int 1-
165> | power <int 1-100>}(1)]
Parameters
<macaddr> - Enter the Managed AP MAC Address used here.
debug - Specifies to enable or disable the AP debug mode.
disable - Specifies that the AP debug mode will be disabled. This is the default option.
enable - Specifies that the AP debug mode will be enabled.
radio - Specifies the radio interface on the managed AP.
<int 1-2> - Enter the radio interface number used here. This value must be either 1 or 2.
channel - (Optional) Specifies that channel to configure on the managed AP.
<int 1-165> - Enter the managed AP's channel number here. This value must be between 1
and 165.
power - (Optional) Specifies the power configured, for the radio, on the managed AP.
<int 1-100> - Enter the power value used here. This value must be between 1 and 100.
Restrictions
Only Administrators can issue this command.
Example
To enable the AP's debug mode:
Command List
763