Installing The Switch In A Cabinet With Insufficient Front Clearance - Cisco MDS9120 - MDS 9120 Multilayer Fabric Switch Installation Manual

Chapter 2 Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 2-6
Figure 2-7
Installing the Switch in a Cabinet with Insufficient Front
Clearance
This section describes how to use the rack-mount kit provided with the switch to install the Cisco MDS
9100 Series switch into a cabinet with insufficient front-facing clearance. The Cisco MDS 9100 Series
switch is installed rear-facing to provide adequate clearance for the fibre-optic cables. This cabinet meets
OL-21514-01
Attaching the Switch to the Rack
Attaching the Cisco MDS 9148, Cisco MDS 9134 Switch, or the Cisco MDS 9124
Switch to the Rack (Notched Rails)

Installing the Switch in a Cabinet with Insufficient Front Clearance

Cisco MDS 9100 Series Hardware Installation Guide
2-11