Prepare Dishwasher Enclosure - Hotpoint HDA3600RCC - 24" Dishwasher Installation Instructions Manual

installation Preparation - Enclosure
PREPARE DISHWASHER ENCLOSURE
To reduce the risk of shock, fire, or injurg
to persons, the installer must ensure that
the dishwasher is completelg enclosed at
the time of installation.
Para redudr el riesgo de choque, incendio
o lesi6n a personas, el instalador se
debe cerdorar de que la lavadora est_
completamente cerrada en el momento
de la instalad6n.
, The rough cabinet opening must have a minimum
width and depth of 24" and height of 34-1/2" _+1/4"
from the floor to the underside of the countertop.
, The back wall should be free of pipes or wires.
, Adjacent cabinets should be square and plumb to
ensure a good fit. Refer to Figure A.
, For a corner installation, allow 2" minimum
clearance between the dishwasher and the
adjacent wall.
, Provide at least 27" in front of the dishwasher to
allow the dishwasher door to open fullg. Refer to
Figure B.
34-1/2"_+ 1/4"
Underside of
Countertop
to Floor
This Wall Area
must be Free of
Pipes or wires
, The dishwasher must be installed no more than
10 feet from sink for proper drainage.
, The dishwasher must be fullg enclosed on the top,
sides and back.
, The dishwasher must not support any part of the
enclosu re.
I
1' Countertop
DishwosheI
Clearances:
In a corner installation, provide
at least 2" clearance between
[_ the dishwasher and the adjacent
i cabinet, wall or other appliance.
Provide at least 27" of clearance
in front of the dishwasher.
27" Minimum
Figure 8
Squore
and
Plumb
Figure A
Floor MUST
be Even with
Room Floor
Plumbing and Electric Service
Must Enter Shaded Area
• Make sure the floor is level inside the opening and
even with the finished floor of the kitchen. This will
facilitate removal of the dishwasher at a later date
for service, if needed.