Hotpoint HDA3600RCC - 24" Dishwasher Installation Instructions Manual page 7

Dishwasher Installation
CAUTION
Do not remove the wood base until you are ready to
install the dishwasher. The dishwasher will tip over
when the door is opened if the base is removed.
PRECAUCION
No retire la base de madera hasta que est_ listo para
instalar la lavadora de platos. Cuando la puerta se abra,
la lavadora de platos se inclinar6 si la base se retira.
STEP 1:PREPARATION
Locate the items in the installation package and set
them aside for use in the listed steps.
, Screw kit- Steps 5 or 16 and 13
, Junction box cover- Steps 5 or 16
, Drain hose and drain hose clamp- Step 7
, Owners' Manual- Steps 18 and 21
, Product Samples and/or coupons- Step 21
, Conversion leads (Factorg-equipped power cord
models onlg) - Appendix
STEP 2:CHECK DOOR BALANCE
• With the dishwasher on the wood base, check the
door balance bg opening and closing the door.
, The door is properlg balanced if it gentlg drops
from a 1/2 open position and does not rise from
the full open position.
, If necessarg, increase or decrease tension as
shown. Latch the door and adjust springs to
correct ba la nce.
9
Link fullg seated
in hinge arm
Insert Hook Throu,
Hole from Inside of Frame
Figure G
Tip: Avoid service calls for door balance problems.
Make sure the spring end is fullg engaged in a
frame hole and the spring link is fullg seated in the
hinge arm.
STEP 3: REMOVE WOOD BASE
IMPORTANT- Donot
kick offwood base!
Damage will occur.
• Move the dishwasher close to the installation
location and lag it on its back.
, Remove the four leveling
legs from the underside of
the wood base
with a 15/16"
socket wrench.
, Remove and
discard wood
base.
Figure H
• Screw leveling legs back into the dishwasher
frame, approximatelg 3/4" from the frame, as
shown.
STEP 4: REMOVE ACCESS PANEL
AND TOEKICK
The top mounting holes in the access panel are
slotted.
, Remove the lower two 10-16 x 3/8" sheet metal
screws. Do not remove the two top 8-32 x 1/4"
machine thread screws.
, Slide the access panel to the left as far as it will go.
, Gentlg pull the access panel forward to remove
it from the top screws.
Set access panel, toekick and screws aside for use
in Step 20.
Tip: Prevent
tub damage.
Remove onlg
the 3/8" sheet
metal screws
in this step.
This will help
prevent a mix-
up with the
1/4" machine
thread screws
in Step 20.
Do not remove 1//4"
machine-thread screws
in this step
Remove two
3/8" Sheet Metal
Thread Screws
Figure I