Coby DVD938 Instruction Manual page 50

Troubleshooting
Symptom
No Power
There is no picture
or the picture is
distorted
There is no sound
or the sound is
distorted
Page 50
Cause
The AC power cord is
not connected to the
power supply or is not
connected securely
The Video Input mode of
the connected TV is set
incorrectly.
The Video Output mode
is set incorrectly.
The video cable connec-
tion is loose.
The audio cable connec-
tions are loose.
The volume is set at the
lowest level.
The sound is switched
off (MUTE is active).
The disc is in fast for-
ward/rewind playback.
Remedy
Please check that the AC power
cord is connected securely.
Set the TV to the correct source
mode. Most TVs have a "Source"
or "TV/Video" button that changes
the source mode. Please refer to
the documentation provided by
the TV manufacturer for further
assistance.
Press <V-MODE> repeatedly until
the picture becomes normal again.
Connect the video cable securely.
Connect the audio cables securely.
Turn up the volume.
Press <MUTE> on the remote
control to re-enable the sound.
Press <PLAY/PAUSE>.
Coby Electronics Corporation