Coby DVD938 Instruction Manual page 14

DVD938 at a Glance
Name
1 Power/Standby
2 Numeric Keypad
3 GOTO
4 SETUP
5 SOURCE
6 USB
7 A-MODE
8 PLAY/PAUSE
9 V-MODE
10 PROG
11 STOP
12 OSD
13 VOL+
VOL–
Page 14
Turn the unit on or off (standby). The Main Power switch on the
rear panel must be set to the ON position.
<0-9, 10>: Use the numeric keypad to input numbers where
appropriate.
<+10>: Add 10 to input numbers higher than 10. For example,
press <+10> twice and then press <5> to input the number "25".
Enter Direct Access mode to go to a specific part of a movie.
Enter the main setup menu of the unit.
Change the source input mode of the unit (e.g., DVD-VIDEO, LINE,
TUNER).
Change the source input mode between DVD, USB, and CARD.
Press <SOURCE> to place the unit in DVD mode first to access the
USB and memory card source modes.
Toggle the audio mode between STEREO OUPUT and 5.1 CHANNEL
OUTPUT.
Play or pause the disc.
Change the video output mode of the unit to match the video con-
nection used. Select CVBS for 480i composite video, YUV for 480i
component video, or P-YUV for 480p component video.
Enter Program mode to create a custom playlist.
Press once to stop disc playback. The player will save and resume
playback from the stop location.
Press twice to stop disc playback completely. The player will
resume playback from the beginning of the disc.
Toggle on-screen information display.
Increase the volume level.
Decrease the volume level.
Description
Coby Electronics Corporation