Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Mounting on a Horizontal or Vertical Surface
Follow these steps to mount the access point on a horizontal or vertical surface.
Step 1
Use the mounting plate as a template to mark the locations of the four mounting holes.
Note
Step 2
Drill one of the following sized holes at the locations you marked:
•
•
Install the anchors into the wall if you are using them. Otherwise, go to Step 4.
Step 3
Secure the mounting plate to the surface using the #8 fasteners.
Step 4
Note
Step 5
Attach the access point to the mounting plate.
Note
OL-8371-05
When mounting on a vertical surface, position the cable security bracket on the bottom.
3/16 in. (4.7 mm) if you are using wall anchors
1/8 in. (6.3 mm) if you are not using wall anchors
On a vertical surface, mount the plate with the security hasp slot on the top.
For a more secure installation you should attach the mounting plate to a stud or major structural
member and use the appropriate fasteners.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
Mounting on a Horizontal or Vertical Surface
2-9
Advertisement
Table of Contents
Troubleshooting
