Point-To-Point Bridge Configuration; Workgroup Bridge Network - Cisco 1242AG - Aironet - Wireless Access Point Hardware Installation Manual

Network Examples with Autonomous Access Points

Point-to-Point Bridge Configuration

In a point-to-point bridge configuration, two bridges interconnect two LAN networks using a wireless
communication link (see
a root bridge and the other bridge is classified as a non-root bridge.
Figure 1-10

Workgroup Bridge Network

The access point supports a workgroup bridge role to interconnect remote Ethernet workstations to the
main LAN. The workgroup bridge can communicate with an access point (see
bridge (see
Figure 1-11
Figure 1-12
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
1-12
Figure 1-10). The bridge connected to the main LAN network is classified as
Point-to-Point Bridge Configuration
Root bridge
Figure 1-12).
Workgroup Bridge Communicating with an Access Point
Access point
Workgroup Bridge Communicating with a Bridge
Bridge
Non-root bridge
Workgroup bridge
Workgroup
bridge
Chapter 1 Overview
Figure 1-11) or with a
OL-8371-05