Using Preset Tuning - JVC RXD212B - 110 Watts X 7 Receiver Instructions Manual

Tuning in to channels
From the remote control ONLY:
7 Channel Search
You can search and tune in to all channels (including non-
categorized channels).
1
Press XM to select "XM" as the source.
2
Press repeatedly or hold CHANNEL +/– until
the desired channel number appears on the
display.
• Pressing (or holding) CHANNEL + increases the channel
number.
• Pressing (or holding) CHANNEL – decreases the channel
number.
NOTE
While searching, the invalid and unsubscribed channels are
skipped.
7 Category Search
You can select the channel category and tune in to only the
channels included in the selected category.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Press XM to select "XM" as the source.
2
Press CAT 9 or ( CAT.
The receiver enters the Category Search mode.
The category name of the currently selected channel appears
and ">" starts flashing on the display for about 15 seconds.
DIGITAL AUTO
L R
LINEAR PCM
S.WFR
3
Press CAT 9 or ( CAT repeatedly to display
the desired category name on the display
while ">" is flashing.
DIGITAL AUTO L R
LINEAR PCM
S.WFR
4
Press repeatedly or hold CHANNEL +/– until
the desired channel is tuned in.
• Pressing (or holding) CHANNEL + increases the channel
number included in the selected category.
• Pressing (or holding) CHANNEL – decreases the channel
number included in the selected category.
NOTE
While searching, the invalid and unsubscribed channels are
skipped.
18
7 Direct Channel Access
You can tune in to the desired channel directly by entering the
channel number.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Press XM to select "XM" as the source.
2
Press DIRECT.
The receiver enters the Direct Access mode and the numeric
buttons now work for entering channel numbers.
The channel number position starts flashing on the display for
about 5 seconds.
DIGITAL AUTO
L R
LINEAR PCM
S.WFR
3
Press the numeric buttons (0 – 9, h10) to
enter the desired channel number while the
channel number position is flashing.
• For channel number 005, press 5.
• For channel number 010, press h10, 1, then 0.
• For channel number 015, press h10, 1, then 5.
• For channel number 115, press h10, h10, 1, 1, then 5.

Using preset tuning

Once a channel is assigned a preset number, the channel can be
quickly tuned simply by selecting the number. You can preset up to
30 channels.
To store the preset channels
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
From the remote control ONLY:
1
Tune in to the channel you want to preset (see
"Tune in to channels" above).
2
Press MEMORY.
The preset number position starts flashing on the display for
about 5 seconds.
DIGITAL AUTO L R
LINEAR PCM
S.WFR
3
Press the numeric buttons (0 – 9, h10) to
select a preset number while the preset
number position is flashing.
• For preset number 5, press 5.
• For preset number 10, press h10, 1, then 0.
• For preset number 15, press h10, 1, then 5.