Nikon 25452 User Manual page 90

A
Flash Modes
The flash modes listed on the previous page may combine one or more of the following
settings, as shown by the flash mode icon:
• AUTO (auto flash): When lighting is poor or subject is back lit, flash pops up automatically
when shutter-release button is pressed halfway and fires as required.
• Y (red-eye reduction): Use for portraits. Red-eye reduction lamp lights before flash fires,
reducing "red-eye. "
• j (off): Flash does not fire even when lighting is poor or subject is back-lit.
• SLOW (slow sync): Shutter speed slows automatically to capture background lighting at night
or under low light. Use to include background lighting in portraits.
• REAR (rear-curtain sync): Flash fires just before shutter closes, creating a stream of light behind
moving light sources (below at right). If this icon is not displayed, flash will fire as the
shutter opens (front-curtain sync; the effect this produces with moving light sources is
shown below at left).
z
A
Choosing a Flash Mode
The flash mode can also be
selected by pressing the M
button and rotating the
command dial (in P, S, A, and M
modes, raise the flash before
using the M button to choose
the flash mode).
A
The Built-in Flash
For information on the lenses that can be used with the built-in flash, see page 196. Remove
lens hoods to prevent shadows. The flash has a minimum range of 60 cm (2 ft.) and can not
be used in the macro range of macro zoom lenses.
The shutter release may be briefly disabled to protect the flash after it has been used for
several consecutive shots. The flash can be used again after a short pause.
A
Shutter Speeds Available with the Built-in Flash
The following shutter speeds are available with the built-in flash when vibration reduction
(VR) is not used.
Mode
i, k, p, s, w, P, A
n, 0
o
72
Front-curtain sync
M button
Shutter speed
1 1
/ – /
200 60
1 1
/ – /
200 125
1
/ –1 s
200
+
Command
dial
Mode
s S
s M
Rear-curtain sync
Information display
Shutter speed
1
/ –30 s
200
1
/ –30 s, bulb
200