Replacing A Memory Module - Lenovo 410554U Hardware Maintenance Manual

6. Depress the power supply latch
and remove it from the chassis.
7. Ensure that the new power supply is the correct replacement. Some power supplies automatically sense
the voltage, some power supplies are voltage specific, and some power supplies have a voltage-selection
switch. If there is a voltage-selection switch, use a ballpoint pen to slide the switch, if necessary.
Note: For models that have a switch:
• If the voltage supply range is 100–127 V AC, set the switch to 115 V.
• If the voltage supply range is 200–240 V AC, set the switch to 230 V.
8. Install the new power supply into the chassis so that the screw holes in the power supply align with
those in the chassis.
Note: Use only the screws provided by Lenovo.
9. Install and tighten the five screws at the rear of the chassis to secure the power supply. Reconnect all
power supply cables to the drives, adapter cards, and the system board. Make sure to reconnect the
power cable to the graphics cards that require an additional cable.
10. Go to "Completing the FRU replacement" on page 106.

Replacing a memory module

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkStation Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkStation
Safety and Warranty Guide, go to:
http://www.lenovo.com/support.
82
ThinkStation Hardware Maintenance Manual
1 . Slide the power supply assembly toward the front of the computer