Installing The Access Panel - Compaq DL360 - ProLiant - Photon Setup And Installation Manual
Compaq proliant dl360 generation 2 server setup and installation guide
Hide thumbs
Also See for DL360 - ProLiant - Photon:
- Maintenance and service manual (82 pages) ,
- White paper (37 pages) ,
- Safety information manual (204 pages)
Table of Contents
Advertisement
3-10 Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide
Installing the Access Panel
To replace the server access panel after installing hardware options for the
ProLiant DL360 G2 server:
1. Set the access panel on top of the server, aligning the sides of the panel
with the server and allowing the panel to extend past the rear of the
server approximately 0.5 inch (1.25 cm)
2. Slide the access panel toward the front of the unit about 0.5 inch
(1.25 cm)
. When the panel seats properly, the hood latches click
(audibly) into place.
Figure 3-7. Installing the access panel
.
1
2
Advertisement
Table of Contents
