Removing Bezel Blanks - Compaq dc7800 - Convertible Minitower PC Hardware Reference Manual

Removing Bezel Blanks

1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. Remove the computer access panel.
6. Remove the front bezel.
7. Gently pull the subpanel, with the bezel blanks secured in it, away from the front bezel, then remove
the desired bezel blank.
CAUTION:
away at an angle could damage the pins that align it within the front bezel.
Figure 2-6
NOTE: When replacing the subpanel, ensure that the aligning pins and any remaining bezel blanks
are in their proper orientation. The logo on the subpanel should be located at the bottom of the subpanel
when properly oriented.
ENWW
Regardless of the power-on state, voltage is always present on the system board as
Hold the subpanel straight when you pull it away from the front bezel. Pulling the subpanel
Removing Bezel Blanks from the Subpanel (Desktop Shown)
Removing Bezel Blanks 15