Saving Your Settings
After you have made your selections for SETUP, press m to
exit. You see the following prompt:
Save SETUP
Press m to return to the menu to make corrections. Press
SETUP without saving your changes press [Nl and [Ena).
If you saved your changes, the SETUP program resets your
system and the computer runs through its power-on diagnostic
tests.
If something is wrong, however, you see an error message and
a prompt to run SETUP. Follow the instructions on the screen
to run SETUP again to correct it. (You may need to reset the
computer.)
If you have just run SETUP for the first time, the next thing you
need to do is install the operating system on your computer.
See your operating system manuals for instructions.
2-18
Running the SETUP Program
configuration
(Y/N)?