Turning Off The Computer - Epson Equity 386/33 PLUS Setup Manual

Do not press any key yet. (If MS-DOS is already installed on
your system, you will see a prompt to enter the date.) Turn off
the computer as described below.
If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the
instructions below to turn off the computer.
Note
If your computer's configuration does not match the
information stored in the computer's CMOS RAM (defined
through the SETUP pro am), you see an error message and
a prompt to press the &
Then run the SETUP program to correct the information.
(See Chapter 2 for instructions.)

Turning Off the Computer

Whenever you turn off your system, follow these steps:
1.
Save your data and exit any application program you are
using.
2. Check the hard disk drive light and the diskette drive light(s)
to make sure they are not on. Do not turn off the computer
if a drive light is on.
3. Remove any diskette(s) from the diskette drive(s).
4. Press the power button to turn off the computer and then turn
off any peripheral devices (monitor, printer, etc.).
Now go on to Chapter 2 and follow the instructions to run the
SETUP program. When you finish running SETUP, you must
install an operating system before you can run your application
software. See your operating system manual for instructions.
1-18
Setting Up Your System
key. Press [ to continue.