1.44-Mb Diskette Drive - Compaq 5500R - ProLiant - 256 MB RAM Maintenance And Service Manual
For use with pentium ii xeon and pentium iii xeon processor-based servers only
Hide thumbs
Also See for 5500R - ProLiant - 256 MB RAM:
- Setup and installation manual (169 pages) ,
- Integration notes (29 pages) ,
- Configuration manual (9 pages)
Table of Contents
Advertisement
2-20 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
1.44-MB Diskette Drive
To remove the diskette drive:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Remove the top access panel. See "Top Access Panel" earlier in this chapter.
4. Remove the front fan nearest to the diskette drive. See "Fans" earlier in this chapter.
5. Disconnect all diskette drive cables.
6. Remove the screw on the side of the diskette drive.
7. Pull the drive back, then lift it through the top of the chassis.
Figure 2-14. Removing the diskette drive
Reverse steps 1 through 7 to replace the diskette drive.
For use with Pentium II and Pentium III Xeon processor-based servers only
Advertisement
Table of Contents
