Table of Contents
Advertisement
Wi-Fi Direct Setup and Settings
You can configure your device to connect directly with other
Wi-Fi capable devices. This is an easy way to transfer data
between devices. These devices must be enabled for Wi-Fi
direct communication. This connection is direct and not via a
HotSpot or WAP.
Note: Activating this feature will disconnect your current Wi-Fi
network connection.
To give your Wi-Fi Direct connection a unique name:
It can be difficult to pair to external devices if all you have is
a generic name (ex: Android 12345). It is recommended you
provide your connection with a unique name.
1. Press
Wi-Fi Direct.
2. Press and then tap Device name.
3. Edit the current name and tap OK to save the new
identification.
and then tap Settings
More...
To activate your connection:
1. Press
2. In a single motion touch and slide the Wi-Fi Direct slider
OFF
to the right to turn it on
check mark displayed next to the feature indicating it is
enabled.
3. Read the on-screen information and tap OK.
4. Tap Scan. After scan, tap a device name to begin the
connection process to another Wi-Fi Direct compatible
device.
Note: The target device must also have Wi-Fi Direct service
active and running before it can be detected by your
device.
5. Tap Connect. The direct connection is then established.
6. When prompted to complete the connection, tap OK.
The status field now reads "Connected" and your
connected device is listed within the Wi-Fi Direct
devices listing.
and then tap Settings
More....
ON
Changing Your Settings
. A
240
Advertisement
Table of Contents
