Eagle FishElite 640c Installation And Operation Instructions Manual page 147

the arrow keys — command — or by setting the track
S A
TEER WITH RROWS
and speed in the dialog boxes provided on the simulator menu screen.
To get to the GPS Simulator:
1. Press | |↓ to | .
MENU MENU GPS S ENT
ETUP
2. Press ↓ to
| . The GPS Simulator Menu appears.
GPS S ENT
IMULATOR
GPS Setup Menu (left). GPS Simulator menu (center).
Map Page showing Steer with Arrows dialog boxes (right). The trav-
eler is following a track of 144º at a speed of 71 miles per hour.
Choose the desired settings, then turn on the simulator by highlighting
the box and pressing . Press repeatedly to get
GPS S O ENT EXIT
IMULATOR N
back to the main page display. A message and tone appear periodically
to remind you the simulator is on. To turn off the simulator, repeat the
steps above or turn off the unit.
If you selected the Steer with Arrows command and want to remove the
dialog boxes from the screen, press . That will clear the track and
EXIT
speed boxes without disrupting the simulation and allow you to use the
map cursor.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
S P
TARTING O-
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set to zero. Select command and press ,
S S A ENT
PEED TEER WITH RROWS
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
139