Table of Contents
Advertisement
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to erase this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER
|
|
EXIT
EXIT
EXIT
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set
to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
4. Press
to turn off the steering and speed boxes. The unit will now
EXIT
automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.
Tip:
You can pick any spot on the map to begin your simulation session
by using the Initialize GPS command. This makes your unit think
it's located at the position you select. See its entry following the en-
try for Hide GPS Features.
Hide GPS Features
If there is no GPS antenna/receiver module attached to this unit, the
GPS menus and features can be hidden from view with this command.
The default setting is off, allowing you to rotate between the Sonar
Page and the GPS pages and features. To hide GPS features:
box and pressing
O
N
A
WITH
RROWS
to return to the previous page.
S
TEER WITH
to clear the alarm.) When navigation starts,
EXIT
key. Press
ENT
to clear the steering and
EXIT
command, press
command and press
A
RROWS
146
|
|
EXIT
EXIT
, then Press
ENT
S
TARTING
EXIT
P
O-
,
ENT
Hide quick links:
Advertisement
Table of Contents
