Table of Contents
Advertisement
Connect the camera to a PC via the USB connection cable A
(supplied).
•
Do not use any other USB connection cables except the supplied one. Use of
cables other than the supplied USB connection cable may cause malfunction.
Press 3/4 to select [PC], and then press [MENU/
SET].
•
If [USB MODE]
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since
there is no need to set this each time you connect to the PC, it
is convenient.
•
When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC's screen. Select [Cancel] to close
the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC]
again.
Double-click on [Removable Disk] in [My Computer].
•
When using a Macintosh, the drive is displayed on the desktop. ("LUMIX", "NO_NAME"
or "Untitled" is displayed.)
Double-click [DCIM] folder.
Using a drag-and-drop operation, move the pictures you want to
acquire or the folder storing those pictures to any different folder on
the PC.
∫ Disconnecting the USB connection cable safely
•
Proceed with the hardware removal using "Safely Remove Hardware" on the task tray of the
PC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCD monitor of
the digital camera before removing the hardware.
Note
•
Turn the camera off before connecting or disconnecting the AC adaptor (optional).
•
Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
Connecting to other equipment
(P63)
is set to [PC] in the [SETUP] menu in
- 180 -
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT
SET
Advertisement
Table of Contents
