Installer Setting - Installer Setting Code Table - LG UV36.NKD Owner's Manual

Installer Setting - Installer Setting Code Table

Installer Setting Code Table
No. Function
0 Mode Override
Ceiling Height
1
Selection
Group Control
2
Auxiliary heater
Mode Override
This Function is only for Non-Auto Changeover H/P model.
Ceiling Height Selection
Our products provide variety of air volumes and capacities according to the selection of ceil-
ing heights.
Cooling/Heating performance is enhanced with relation to ceiling height.
- The highest/cooling heating performance and efficiency are provide at super high.
(Some noise may be generated according to the level height setting.)
Group Control
This function is only for group control. Please don't set this function in case of non-group
control.
After setting Group Control of the product, turn off the power then turn it back on after 1
minute.
Auxiliary heater
This function is only applied to models with Auxiliary Heater function being activated.
Function Code
0 : Set to Master
0
1 : Set to Slave
1 : Standard
2 : Low
1
3 : High
4 : Super High
0 : Set to Master
2
1 : Set to Slave
2 : Check Master/Slave
3 : Set to Auxiliary heater
2
4 : Cancel Auxiliary heater
5 : Check Auxiliary heater Installation
INSTALLATION INSTRUCTIONS
Setting Value
13
Remote Controller LCD