Garmin aera 560 Pilot's Manual page 174

Appendix D
Attaching the yoke mount to the yoke shaft or control arm:
1) Open the clamp by turning the Clamp Adjustment Knob until it can be
easily placed over the yoke shaft or control arm. Install the yoke mount as
far from the panel as is practical.
2) When in place, tighten the Clamp Adjustment Knob to secure the yoke
mount to the yoke shaft or control arm.
3) Loosen the Cradle Adjustment Knob, then orient the aera as desired.
4) Tighten the Cradle Adjustment Knob to hold the aera in place.
5) Connect power/data cables.
Attaching the aera to the yoke mount:
1) Fit the bottom of the aera into the cradle.
2) Tilt the aera back until it snaps into place.
Removing the aera from the yoke mount:
1) Press the Release Button on the side of the mount to release the aera.
2) Lift out the aera.
aera
158
aera Cradle
Release Button
Cradle Adjustment Knob
Yoke Mount Assembly
Garmin aera 500 Series Pilot's Guide 190-01117-02 Rev. C