Loading Cut Sheet A3 Size Or Larger / Thick Pa; Per - Epson Stylus Pro 7890 User Manual

Epson Stylus Pro 9890/9908/7890/7908
D
Load the sheet into the paper insertion slot
until it meets resistance.
Align the right edge of the paper with the
setting position, and then insert the paper
until it meets resistance. When using paper
sizes A4 or below, set the paper until it
reaches the bottom along the line on the
metal part under the paper insertion slot.
BUTTON appears on the LCD
PRESS THE
panel.
Note:
Load the sheet vertically, like most magazines.
E
Press the button.
The paper moves to the start position.
F
If ARE THESE SETTINGS OK? appears on the
LCD panel, press the
select NO and then press the
the media type and paper remaining, and
then press the
The previous setting appears on the LCD
panel. If the media type and paper
remaining are correct, select YES and then
press the button.
G
If you use the paper basket, set it backward
position.
See "Using the paper basket and paper
guides" on page 42
User's Guide
Paper Handling
or button to
button. Set
button to set the media.
Loading cut sheet A3 size or
larger / thick paper
When you load a cut sheet media A3 or larger or
thick paper (0.5 to 1.5 mm), follow the steps
below.
Paper is normally loaded vertically.
Thick paper can be up to 762 mm in length.
However, if you are using the Epson Stylus Pro
9890/9908, you can load thick paper longer than
762 mm if you load it horizontally.
A
Turn on the printer by pressing the
button.
B
Press the button repeatedly until Sheet
appears.
C
Make sure that the roll paper cover is
closed.
D
Press the
39
button.