About Roll Paper Cutting - Epson Stylus Pro 7890 User Manual

Epson Stylus Pro 9890/9908/7890/7908

About Roll Paper Cutting

When performing borderless printing on roll paper, you can specify whether it is left and right borderless
printing or all edges borderless printing, and how to cut the paper in the printer driver's Roll Paper
Option. The cutting operation for each value is shown in the following chart.
Printer driver
Normal Cut
settings
Cutting
Operation
The default printer driver
setting is Normal Cut.
Explanation
User's Guide
Printing Varieties
Single Cut
❏
The top area may
become slightly
uneven depending on
the image since the
print operation stops
while cutting the top
edge of the roll paper.
❏
If the cut position is
misaligned slightly,
small parts of the
image may be shown
on the top or bottom of
the adjacent pages. If
this occurs, perform
Cutter Adjustment.
See
"MAINTENANCE" on
page 23
❏
When printing only one
page the operation
performed is the same
as that for Double Cut.
When continuously
printing multiple sheets,
the printer cuts 1 mm
inside on the top edge
of the first page and
the bottom edge of
the subsequent pages
to avoid showing
margins.
132
Double Cut
❏
The top area may
become slightly
uneven depending on
the image since the
print operation stops
while cutting the top
edge of the roll paper.
❏
The printed paper is
approximately 2 mm
shorter than the
specified size since the
printer cuts the paper
inside the image to
avoid showing top and
bottom margins.
❏
After cutting the
bottom edge of the
previous page, the
printer feeds the
paper, and then cuts
the top edge of the
following page.
Although this produces
80 to 127 mm cut-off
pieces, the cut is more
accurate.