Epson AcuLaser C9300N User Manual page 98

Epson AcuLaser C9300 Series User's Guide
Need Memory
The printer has insufficient memory to complete the current print job.
To clear this error message, select Clear Warning from the control panel's Reset Menu. See"How to
access the control panel menus" on page 60 for instructions.
To prevent this problem from recurring, add more memory to your printer as described in "Memory
modules" on page 198, or reduce the resolution of the image to be printed.
No trays available Press Cancel Job
All of the MP Tray AutoSel, Cassette1 AutoSel, Cassette2 AutoSel, Cassette3 AutoSel,
and Cassette4 AutoSel settings in Tray Menu are set to Off, so the printer cannot feed paper. Press
the W Pause/Cancel button to cancel the print job. To continue printing, specify the paper source
on the printer driver, or set the above settings in Tray Menu to On.
Non-Genuine Toner Cartridge
The installed toner cartridge is not a genuine Epson product. Installing a genuine toner cartridge is
recommended. The printout and remaining service life of each toner cartridge displayed on the
control panel may be different from those when using genuine Epson toner cartridges. Epson shall not
be liable for any damages or problems arising from the use of consumable products not manufactured
or approved by Epson.
Install a genuine Epson product, or Clear All Warnings of the Reset Menu on the control panel to
clear the warning message. See "Replacing Consumable Products" on page 133 for instructions on
replacing the toner cartridge.
Non-Genuine Toner uuuu
The installed toner cartridge is not a genuine Epson toner cartridge. The printout and remaining
service lives of the toner cartridges displayed on the control panel may be different from those when
using genuine Epson toner cartridges. Epson shall not be liable for any damages or problems arising
from the use of consumable products not manufactured or approved by Epson. Installing a genuine
toner cartridge is recommended. Press the Start/Stop button on the control panel to resume printing.
Not Supported USB Device XXX
The device is not supported. Remove it from the USB port.
Offline
Using the Control Panel 98