Condensed Water; Electrical Installation - Asko T743C Operating Instructions Manual

Installation instructions

Condensed water

Install the dryer so the condensed water will
continuously flow into a drain or sink. To do this,
follow the instructions below:
1. Connect the rubber hose supplied with the
dryer to the blue nipple.
2. Run the hose to a drain or sink, as illustrated.
The drain hose must not be more than 40" above
the floor.
22
1

Electrical installation

WARNING!
The receptacle on the rear of the machine is
designed to accommodate ASKO washers ONLY
(rated 208–240 V.) To use this receptacle, you
must use the ready-fitted plug supplied with the
washing machine or an equivalent.
ASKO washers rated 208–240 V have two
internal fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
WARNING!
This appliance must be properly grounded. Refer
to the "Important Safety Instructions" for
grounding instructions.
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply
must be protected by a residual current device.
Connection to a permanently wired supply point
must be made only by a qualified electrician. As
supplied: Single-phase, 230 V, 60 Hz, 2500W
heater rating 30 A circuit required
Customer Care Center
1-800-898-1879
www.askousa.com
2
Maximum
height 40"
2a