Documentation Updates - Cisco 3020 - Catalyst Blade Switch Release Note

•
•
•
•
•
•
•
•
•
•

Documentation Updates

•
OL-18274-02
CSCsv63345
When you enter the show interface command, the bandwidth and delay fields now display correct
information for all ports.
CSCsv64023
A switch port configured for IGMP snooping no longer lose its group membership when the port
receives a query comes from an upstream device that is not configured for IGMP snooping.
CSCsv89005
A switch configured with class-based policies that are applied and active on at least one interface no
longer might reload or display CPU hog messages during SNMP polling for the ciscoCBQosMIB.
CSCsv91358
When you have entered the vlan dot1q tag native global configuration command to configure a
switch to tag native VLAN frames on 802.1Q trunk ports, and you configure a new voice VLAN on
an access port, the MAC address of a connected PC is now correctly relearned.
CSCsw30249
When a switch virtual interface (SVI) is configured as unnumbered and is pointing to a loopback
interface, the switch no longer fails when the SVI receives a packet.
CSCsw45337
When LLDP is enabled and a voice VLAN is configured, the L2 Priority and DSCP Value fields in
the LLDP type, length, and value descriptions (TLVs) are now correctly marked to give the voice
traffic the correct DSCP and Layer 2 priority.
CSCsw65548
Switch ports no longer attempt authentication at the interval configured for the port security timer
instead of the configured IEEE 802.1x timer.
CSCsw68528
On switches running Cisco IOS Release 12.2(44)SE or 12.2(46)SE, when you enter the show mvr
interface interface-id members privileged EXEC command to see status of an MVR port, an MVR
member port that is not connected always shows as ACTIVE.
The workaround is to use the show mvr interface interface-id or the show mvr members privileged
EXEC command. These command outputs show the correct status of an MVR port.
CSCsw69015
When you enter the mvr vlan vlan-id global configuration command to create an MVR VLAN and
enable MVR on the switch by entering the mvr global configuration command, if you enter the show
mvr interface interface-id members privileged EXEC command, the output shows the MVR
groups on the interface. However, if you enable MVR first and then create the MVR VLAN, the
MVR groups are not displayed correctly.
The workaround, if the groups are not displaying correctly, is to create the MVR VLAN before
enabling MVR. The configuration then displays correctly.
CSCsx27883
The MIB chassisPs2Status no longer returns the incorrect value, 1, for a secondary power supply.
"Updates to the Command Reference" section on page 18
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
Documentation Updates
17